When people realize that the tap water is not of the best quality right now, they install one of the most popular cleaning filters, Aquafor. But over time, the filtration system needs to replace the cartridges, so you'll have to find out how to change the Aquafor filter anyway in order to be able to continue using clean water, free of all impurities.

If the pressure from the tap suddenly decreased, this can be considered the first alarming sign, which indicates that the Aquafor filter needs to be changed urgently, because it is clogged with dirt and no longer provides a high level of drinking water purification.

When installing the Aquafor filtration system, it is worth knowing that, on average, the cartridges are designed to purify no more than 7 thousand liters of water, and it is also important to take into account the quality of the water supplied through the pipes. It is recommended to change the Aquafor filter after 6-12 months of use by a family with up to four people. Replacement of filters of the type "Crystal" and "Trio" is performed approximately according to the same scheme, which must be specified in the instructions for the cleaning system.

If one is lost or missing, follow the following recommendations, which will help you change the Aquafor filter yourself. To carry out the replacement procedure, the water supply must first be shut off. This can be done by turning the tap mounted on the wiring tee, which is located in front of the cleaning flasks, only then you can change the Aquafor filter without such consequences as flooding.

To change the Aquafor filter, you need to open the faucet that supplies filtered water. And this is done in order to lower the residual pressure. After completing the simple two steps, you can take the included wrench and tighten the nuts that hold the cartridge. It is possible to change the Aquafor filter by unscrewing the cartridge clips just with your hands, if you have enough strength. To prevent the remnants of dirty water from spilling onto the floor, it is recommended to substitute a convenient container or lay a cloth. When removing the filtration flask, the contents of the cartridge will necessarily pour out.

If you need to change the Aquafor filter, you start with a cartridge for coarse water purification, then remove the flask with ion exchange resin, and finally change the carbon filter. Each subsequent cartridge must be replaced after the previous one has been installed. You can change the Aquafor filter and ensure its reliable operation by tightening all the installed filtration flasks well. Only then is it acceptable to reopen the tap water supply.

Recommendations

- When the system is fully ready for operation, it is necessary to follow the following recommendation: open the tap through which filtered water is supplied and let it drain for 10-15 minutes. Do not be afraid, but first a dirty liquid will come out of the tap, and after a specified time the water will already be suitable for its consumption and drinking. 1xbet รหัสโปรโมชั่น